Share thisThere will be two firmware files, The *.mbn, main firmware file, and *.fbn, the filesystem file Now open setoollite program, and do the following…
1. Choose a port (if cable DCU-60 or equivalent, the USB), speed
2. Choose your phone
3. Click on Clear
4. Click Add and select MAIN- file, click Add again and select FS- file.
5. Connect it to the datacable keeping the “c” key pressed!, press flash!
6. In a log of this information will be approximately:
Flash props sent ok
writing E:\ XXX_RXXXXX_MAIN_GENERIC_REDXX.mbn
CURRENT FLASH FILE CID:XX
SSW uses complete hash, hash len is:XXXX
Will flash XXX blocks…
SSW loading returns:0
writing E:\ XXX_RXXXXX_FS_RUSSIA_REDXX.fbn
CURRENT FLASH FILE CID:XX
SSW uses complete hash, hash len is:XXXX
Will flash XXx blocks…
SSW loading returns:0
Elapsed:XXX secs.
After this process you need to finalize your phone disconnect from pc remove reinsert battery dont switch on your phone and do the following
Finalizing(To be done after flashing)
1. Choose a port (if cable DCU-60 or equivalent, the USB), speed
2. Clean the old ways click Clear. Choose your phone
3. In the Misc files, select the file Misc customization package(zipped)
4. Connect it to the datacable keeping the “c” key pressed!, Press flash
5. When the window with a log message:
DETACH FROM CABLE PHONE.
REMOVE FROM PHONE BATTERY, INSERT IT BACK THEN
THEN PRESS “READY”
then unplug the cable, remove the battery, put the battery back, plug and click READY. 7. Further, a log message:
Phone detached
Elapsed: XX secs.
2. Clean the old ways click Clear. Choose your phone
3. In the Misc files, select the file Misc customization package(zipped)
4. Connect it to the datacable keeping the “c” key pressed!, Press flash
5. When the window with a log message:
DETACH FROM CABLE PHONE.
REMOVE FROM PHONE BATTERY, INSERT IT BACK THEN
THEN PRESS “READY”
then unplug the cable, remove the battery, put the battery back, plug and click READY. 7. Further, a log message:
Phone detached
Elapsed: XX secs.
